How to Make A Miter Saw Table (With Pictures)

The following steps are meant to guide you in making your own miter saw table. you can use the miter saw table in either your shop or a job site. Buying a miter saw table can be a little costly, but making one can save lots of bucks. The steps are easy to follow and the pictures are there to visualize the steps for you:

#1 Measure the Deck of the Miter Saw Table

Find the exact measurement of the height of the outfeed and infeed tables. The height measurement should be the same as the saw deck’s depth to make sure the support is seamless. To get an accurate measurement, use a marking gauge to measure the flat surface of the saw deck’s top.

Making a miter saw table

#2 Mark the Plywood

Make the mark of the project pieces on the plywood sheet: one sheet of ¾” plywood for all the needed wood and two sides for 4 panels and 2 top pieces. After that, cut the pieces and use the remaining pieces to make any necessary smaller pieces. The cuts should cover at least 2 sides of 9”x8” and 4 box ends of 9”x16”.

Making a miter saw table

#3 Put a Mark for the Notches

Make a sign on the two-side pieces for marking the location of the notches. Mark the depth of the notch using the measurement from step one. Make sure that the notch’s width is the same as the width of the miter saw’s swing bevel with an additional or plus 6”.

#4 Make Crosscuts and Plunge Cuts

Using the measurement from step one, set the fence of the table saw to the right depth. For the crosscuts, do it with a circular saw. Use a hand saw to finish cutting the notch out.

Making a miter saw table

Making a miter saw table

#5 Attach the Table Top and Connect the Table Corner

Find a flat and large surface to place the two-side pieces upright. Place the box ends between the pieces. Then, keep the miters square by screwing gussets into the table corners. Before putting the tabletop, remove the gussets and screw the corners. Then, put the top on every box.

#6 Attach Skids to the Saw

First, take some leftover plywood and then make two skids. One skid is for comprising two pieces (the bottom and the top). To make sure the skid fits the box sides easily, the bottom skid needs chamfering. Next, use ¾” plywood to measure the chamfered skid’s end. Finally, secure the position of the skids by screwing them and also by screwing the skids to the saw.

Making a miter saw table

Making a miter saw table

Making a miter saw table

Danny K
We will be happy to hear your thoughts

Leave a reply